Too tight or blocked damping rollers may lead to rupture of the body.
Reduce the contact pressure so the rollers can be rotated with little effort in passive state. Replace blocked damping rollers
The tooth gullet is too small. Chips will overfi ll the tooth gullet and lift the blade. When the chip clears the gullet, the blade will be forced back into the cutting channel resulting in a shock load on the tooth. Leading to tooth damage.
Select a coarser tooth pitch.
Incorrect alignment causes burrs at the band back edge, followed by microcracks. Result: Blade breakage.
Adjust wheels. Keep a clearance between band back edge and fl ange of the wheels. (Recommended clearance: 0.5 to 1.5mm).
Teeth have no guide in the cutting channel. Resulting in high tooth loads at the cutting point. Result: Fractures and breakages as well as microcracks in the tooth gullet.
Use finer tooth pitch.
|Auf dem Knapp 42
|42855 Remscheid | Germany
|+49 2191 373-770
|+49 2191 373-799